I selected a drill bit which was the same size or with a smaller diameter then the shaft of the screws. I then marked the locating for the pilot holes (I actually ended up drilling with the machine heads still on) 0 ratings 0 found this document useful (0 votes) 140 views. I just pushed the pegs all the way through, loosely fitting the nuts and washers at the front, and lined up the machine heads until I was happy they were straight. Gibson MinETune Manual-2012 v1 - Free download as PDF File (.pdf), Text File (.txt) or view presentation slides online. This is what you're left with once it's been removedįirst step was to provisionally fit all the machine heads for alignment So once I got to the last peg, I had to hold the Min-ETune unit to prevent it from falling off This is the only thing holding on the machine heads and the Min-ETune unit. I then carefully unfastened the nuts on the tuner pegs at the front of the headstock Strings off, along with the bridge and saddles They will screw all the way off so you have to be careful not to lose them Gibson original product PMMH-010 First step was to provisionally fit all the machine heads for alignment I just pushed the pegs all the way through, loosely fitting the nuts and washers at the front, and lined up the machine heads until I was happy they were straight. You can still adjust the tuning pegs manually or turn on the Min-ETune to. The nuts which clamp the strings in place have to be unscrewed a little to remove the strings Gibson USA LPS14RTRC1LP Standard 2014 Rootbeer Burst Perimeter Min-ETune. I prepared by unwinding the strings as per the user manual for the Min-ETune. (The Min-ETune tuners do not use screws). 144K views 10 years ago Get Your Gibson Min-Etune Guitar Today at AMS - Min-Etune takes the hassle out of tuning by tuning and fine-tuning your instrument using. The only drilling required is for the pilot holes for the screws of the new machine heads. The headstock holes for the pegs of the machine heads are a standard Gibson size (roughly 10mm diameter) and will take standard Gibson machine heads. It was a simple process which required no reaming. Here are a few photos showing how I replaced the Min-ETune unit and machine heads on my 2014 SG Standard.
0 Comments
Leave a Reply. |